Headlight Lamp Replacement; Brake Lights - Polaris Ranger 1000 Diesel Owner's Manual

Lights
Poor lighting can result in reduced visibility when driving. Headlight and taillight lenses
become dirty during normal operation. Clean lights frequently and replace burned out lamps
promptly. Do not operate this vehicle at night or in low light conditions until the headlight is
replaced. Always make sure lights are adjusted properly for best visibility.
When servicing a halogen lamp, don't touch the lamp with bare fingers. Oil from your skin
leaves a residue, causing a hot spot that will shorten the life of the lamp.

Headlight Lamp Replacement

Access a headlamp wiring harness through the front
wheel well.
CAUTION! Hot components can cause burns to skin.
Allow lamps to cool before servicing.
1. Unplug the headlamp from the wiring harness.
Be sure to pull on the connector, not on the
wiring.
2. Turn the lamp counter-clockwise to remove it.
3. Install the new lamp.
Tip: Make sure the tab on the lamp locates properly in the
housing.
4. Reinstall the harness assembly into the headlight
assembly.

Brake Lights

When the brake pedal is depressed, the brake light comes on. Check the brake light before
each ride.
1. Turn the ignition switch to the ON position.
2. Depress the brake pedal. The brake light should come on after about 10 mm (0.4 in.) of
pedal travel.
MAINTENANCE
Connector
91