Steering Wheel Inspection; Headlight Lamp Replacement - Polaris 2016 RANGER EV Li-Ion Owner's Manual

Steering Wheel Inspection

Check the steering wheel for specified freeplay and smooth operation at the intervals
outlined in the Periodic Maintenance Chart beginning on page 54.
1. Position the vehicle on a level surface.
2. Lightly turn the steering wheel left and right. There should be 0.8"-1.0" (20-25 mm) of
freeplay at the outer rim of the steering wheel.
3. If there is excessive freeplay or strange noises, or the steering feels rough or "catchy,"
have the steering system inspected by an authorized POLARIS dealer.
Lights
Poor lighting can result in reduced visibility when driving. Headlight and taillight lenses
become dirty during normal operation. Clean lights frequently and replace burned out lamps
promptly. Do not operate this vehicle at night or in low light conditions until the headlight is
replaced. Always make sure lights are adjusted properly for best visibility.
When servicing a halogen lamp, don't touch the lamp with bare fingers. Oil from your skin
leaves a residue, causing a hot spot that will shorten the life of the lamp.

Headlight Lamp Replacement

1. Open the hood.
CAUTION! Hot components can cause burns to skin. Allow
lamps to cool before servicing.
2. Unplug the headlamp from the wiring harness. Be
sure to pull on the connector, not on the wiring.
3. Turn the lamp counter-clockwise to remove it.
4. Install the new lamp.
Tip: Make sure the tab on the lamp locates properly in the
housing.
5. Reinstall the harness assembly into the headlight
assembly.
MAINTENANCE
Wiring Harness
View From Bottom
59