Attaching.the.silicon.oil.lubricating.unit; Attaching.the.belt.cover - JUKI MH-486-5 Instruction Manual

. 5 .. ATTACHING.THE.SILICON.OIL.LUBRICATING.UNIT

. 6 .. ATTACHING.THE.BELT.COVER

WARNING.:
To.avoid.possible.personal.injury.due.to.abrupt.start.of.the.machine,.turn.off.the.power.to.the.machine.and.check.to.be.sure.that.the.
motor.has.totally.stopped.rotating.in.prior.
1
4
6
5
2
3
6
5
1. Insert belt cover support 1 into the tapped hole in the machine arm.
2. Temporarily fix belt cover 2 on the machine head with screws.
3. Slightly tilting the machine head, put rid 3 of the belt cover inside the
outer pulley and fix rid 3 with four screws.
4. Fix rid 3 on support 1 .
5. Loosen the screws in the belt cover, and adjust the position of belt cover
2 properly. Then securely tighten the screws in the belt cover.
6. Fix bobbin winder cover 4 with three screws.
7. Fix belt cover auxiliary plate 5 as illustrated in the figure.
(Caution). 1.. When.tilting.the.machine,.loosen.wooden.screw. 6 .in.
belt.cover.auxiliary.plate. 5 .and.move.the.auxiliary.
plate.in.the.direction.of.the.arrow.to.such.an.extent.
that.it.does.not.come.in.contact.with.the.belt.cover.as.
shown.in.the.figure.
. 2.. After.you.have.raised.the.machine,.return.belt.cover.
auxiliary.plate. 5 .to.the.previous.position.
– 4 –