Yamaha QBIX LTV125 Owner's Manual page 90

Periodic maintenance and adjustment
(LTV125-A)
1
1. Spare fuse
2. ABS solenoid fuse
3. Main fuse
4. Backup fuse
5. ABS control unit fuse
6. Sub fuse
7. Auxiliary DC connector fuse
If a fuse is blown, replace it as follows.
1. Turn off the electrical circuit in
question, and then turn off the
9
main switch.
2. Open the seat. (See page 6-16.)
3. Remove the battery cover by re-
moving the screws.
2
1
3
4
5
6
7
1. Battery cover
2. Screw
4. Remove the blown fuse, and then
install a new fuse of the specified
amperage. WARNING! Do not
use a fuse of a higher amperage
rating than recommended to
avoid causing extensive dam-
age to the electrical system and
possibly a fire.
2
5. Turn the main switch on, and then
TIP
[EWA15132]
If the fuse immediately blows again,
have a Yamaha dealer check the elec-
trical system.
6. Install the battery cover by install-
7. Close the seat.
9-26
Specified fuses:
Main fuse:
15.0 A
Sub fuse:
10.0 A
Auxiliary DC connector fuse:
2.0 A
ABS motor fuse:
10.0 A (LTV125-A)
ABS solenoid fuse:
10.0 A (LTV125-A)
ABS control unit fuse:
2.0 A (LTV125-A)
Backup fuse:
10.0 A
turn on the electrical circuit in
question to check if the device op-
erates.
ing the screws.