NOTICE
If a warning or indicator light does
not work as described above, see
page 6-4 for the corresponding
warning and indicator light circuit
check.
2. Close the throttle.
3. While applying the front or rear
brake, push the start switch. Re-
lease it when the engine starts.
TIP
If the engine does not start, re-
lease the start switch after 5 sec-
onds. Before pressing the start
switch again, wait 10 seconds to
allow battery voltage to restore.
When the Stop and Start System
is activated, turning the throttle
grip will start the engine. (See
page 5-1.)
For LTV125/LTV125-R, if the en-
gine will not start by pushing the
start switch, try using the kick-
starter.
Operation and important riding points
ECA22510
NOTICE
For maximum engine life, never ac-
celerate hard when the engine is
cold!
ECA11043
Starting off
1. While pulling the rear brake lever
1. Grab bar
2. Sit astride the seat, and then ad-
3. Switch the turn signals on.
4. Check for oncoming traffic, and
5. Switch the turn signals off.
8-2
with your left hand and holding the
grab bar with your right hand,
push the scooter off the center-
stand.
just the rear view mirrors.
then slowly turn the throttle grip
(on the right) in order to take off.
EAU45093
1
8