Table of Contents
Advertisement
a.
If the interposer has a pull strap, move the pull strap away from the storage interface card. If
the pull strap surrounds the storage interface card, the pull strap will interfere with the removal
of the interposer card.
b.
Press out on the plastic latch that holds the interposer card to the storage interface card and
simultaneously lift up on the controller, as shown.
c.
Separate the interposer card from the storage interface card and store the interposer card
in a safe place.
Step 8.
Install the backup-battery cable to the storage interface card.
a.
If you are installing a ServeRAID-MR10ie controller, select cable "B" from the packaging.
b.
Locate the end of the cable marked "EXPANSION CARD"; then, with the blue side of the
cable end facing up, carefully insert the cable end into the cable connector on the ServeRAID
controller.
Step 9.
Orient the connector on the storage interface card with the CIOv expansion connector on the
system board; then, press the storage interface card into the CIOv expansion connector.
Step 10. Firmly press on the indicated locations to seat the storage interface card.
Note: For device-driver and configuration information to complete the installation of the expansion
card, see the documentation that comes with the storage interface card.
Step 11. Install the backup battery for the storage interface card into DIMM connector seven (see "Blade
server connectors" on page 14 and "Installing a memory module" on page 24).
44
BladeCenter HS22 Blade ServerInstallation and User's Guide
Advertisement
Table of Contents
