Table of Contents
Advertisement
– Power
Select this choice to view or change power capping to control power consumption and processor
performance states.
– Legacy Support
Select this choice to view or set legacy support.
– Force Legacy Video on Boot
Select this choice to force INT video support, if the operating system does not support UEFI video
output standards.
– Rehook INT
Select this choice to enable or disable devices from taking control of the boot process. The default
is Disable.
– Legacy Thunk Support
Select this choice to enable or disable UEFI to interact with PCI mass storage devices that are
non-UEFI compliant.
– Integrated Management Module
Select this choice to view or change the settings for the integrated management module.
– POST Watchdog Timer
Select this choice to view or enable the POST watchdog timer.
– POST Watchdog Timer Value
Select this choice to view or set the POST loader watchdog timer value.
– Reboot System on NMI
Enable or disable restarting the system whenever a nonmaskable interrupt (NMI) occurs. Disabled
is the default.
– Network Configuration
Select this choice to view the system management network interface port, the IMM MAC address,
the current IMM IP address, and host name; define the static IMM IP address, subnet mask, and
gateway address, specify whether to use the static IP address or have DHCP assign the IMM IP
address, save the network changes, and reset the IMM.
– Reset IMM to Defaults
Select this choice to view or reset IMM to the default settings.
– System Security
Select this choice to view or configure security options.
– Adapters and UEFI Drivers
Select this choice to view information about the adapters and UEFI drivers installed in the server.
– Network
Select this choice to view or configure the network device options, such as iSCSI, PXE, and Broadcom.
– Trusted Platform Module (TPM)
Select this choice to view and configure TPM settings.
• Date and Time
Select this choice to set the date and time in the server, in 24-hour format (hour:minute:second).
This choice is on the full UEFI Setup Utility menu only.
• Start Options
.
Chapter 4
Configuring the blade server
55
Advertisement
Table of Contents
