Advertisement
Available languages
Available languages
FRONT PANEL FEATURES
12
1.
DISPLAY – Shows information pertinent to unit operation.
2.
DOWN BUTTON – This button is used to move down through lists of available options on the DISPLAY.
3.
UP BUTTON – This button is used to move up through lists of available options on the DISPLAY.
4.
RIGHT BUTTON – When a selected option shows a ">" symbol in the DISPLAY, this button may be used to enter and
display available sub-items. When playing music from an attached USB or SD media device, this button functions as a
Skip Forward button, allowing you to skip to the next available track.
5.
LEFT BUTTON – When a selected option shows a "<" in the DISPLAY, this button may be used to go back to the
previous set of options. When playing music from an attached USB or SD media device, this button functions as a Skip
Back button, allowing you to skip to the beginning of the track, or to the previous track, if pressed again.
6.
SELECT BUTTON – This button selects the option highlighted on the DISPLAY.
7.
EXIT – This button returns you to the main set of options (main page).
8.
DELETE – Press this button to delete the selected recording.
9.
SD CARD SLOT – Insert SD card into this slot.
10.
USB SLOT – Insert USB thumb-drive or connect USB hard-drive (FAT16 or FAT32 only) to this input.
Note: The LP2FLASH does not support USB hubs.
11.
USB STATUS INDICATOR – This LED will light when a USB drive is connected.
12.
RECORD VOLUME – This knob adjusts the recording level. As you adjust the recording level, keep an eye on the audio
meters on the DISPLAY.
13.
RECORD – Press this button to enter Record Mode. Record Mode allows you to record music from the turntable platter,
or from external audio devices connected to the LINE IN, directly to a connected USB or SD device.
14.
PLAY / PAUSE – Press this button to play. While playing, press again to pause. While paused, press again to resume
playback.
15.
STOP – Press this button to stop playback (or recording).
16.
35 / 45 RPM BUTTON – This button controls the RPM of the PLATTER. A number on the upper-right-hand corner of the
DISPLAY indicates which RPM mode has been selected.
17.
STOP PLATTER – This button returns the TONEARM to its resting position and stops the turntable motor. If the button
is not functioning, make sure the Motor Drive Belt is properly installed (see ATTACHING THE DRIVE BELT).
18.
LINE IN – Connect a tape player, reel-to-reel machine, or other audio source to this input using a 1/8" stereo cable. Any
signal entering this input will be included in the playback or recording mix.
16
18
11
9
10
8
17
1
7
2
3
6
4
5
13
14
15
2
Advertisement
