Rheem Gas Heavy Duty Water Heater Models 265 Litre and 275 Litre Installation And Owner's Instructions page 6

ABOUT YOUR WATER HEATER
This water heater is supplied with a thermostat, an over-temperature cut-out,
and a combination temperature pressure relief valve. These devices must not
be tampered with or removed. The water heater must not be operated unless
each of these devices is fitted and is in working order.
The warranty can become void if relief valves or other safety devices are
tampered with or if the installation is not in accordance with these
instructions.
TO TURN OFF THE WATER HEATER
If it is necessary to turn off the water heater:
•
Switch off the electrical supply at the isolating switch to the water heater(s).
•
Close the gas isolation valve(s) at the inlet to the gas control(s).
•
Close the cold water isolation valve on the cold water line to the water
heater(s) to shut down the entire system, or;
•
Close the isolation valves on the cold and hot water branches to shut down
an individual water heater in a bank.
TO TURN ON THE WATER HEATER
•
Open the isolation valves fully on the cold and hot water branches to the
water heater(s) installed in a bank.
•
Open the cold water isolation valve on the cold water line to the water
heater(s). Air will be forced out of the taps.
•
Open the gas isolation valve(s) fully at the inlets to the gas control(s).
•
Switch on the electrical supply at the isolating switch to the water heater(s).
HOW DO I KNOW THE WATER HEATER IS INSTALLED CORRECTLY?
Installation requirements are shown on
water heater must be installed by an authorised person and the installation
must comply with National Standards AS/NZS 3500.4, AS/NZS 3000, AS 5601
and all local codes and regulatory authority requirements. In New Zealand the
installation must conform with NZS 5261 Code of Practice for Installation of
Gas Burning Appliances and the New Zealand Building Code.
pages 22 to 23 and
6
pages 32 to 36. The