Yanmar 3TNV82A Troubleshooting Manual page 145

Method and Procedure of Failure Diagnosis
3. Check of harness continuity:
• Remove the accelerator sensor and E-ECU from the harness.
• Check the harness continuity using a circuit tester.
Terminal
Sensor signal wire E35
[Between E-ECU and sensor connector]
Sensor GND wire E28
[Between E-ECU and sensor connector]
Sensor 5V wire E38
[Between E-ECU and sensor connector]
Between E35 and other terminal/GND
and between E38 and other
terminal/GND
Between E28 and GND/E45/E47
Between E28 and other terminals
NG
OK
4. Check of the accelerator sensor output voltage:
• Connect the 2G eco-checker harness between E-ECU and machine's harness (for details, see [How to
use the 2G eco-checker harness] (P.1-135) And connect the all connectors (sensors, E-ECU).
• Measure the voltage between sensor signal E35 and E28 using a circuit tester.
Voltage
E35 ≤ 0.2[V]
0.2[V] < E35 < 4.6[V]
4.6V ≤ E35
NG
OK
TNV DI Service Manual
• Check if the harness is damaged, or if the wiring is correct.
• Replace the harness.
Check the output voltage of the accelerator sensor. → Go to [4. Check of the
accelerator sensor output voltage:]
Status
NG
OK
(Normal range)
NG
• Check if the harness is damaged, or if the wiring is correct.
• Replace the harness.
Replace E-ECU.
Continuity
Available OK: normal
Unavailable NG: harness disconnection
Available OK: normal
Unavailable NG: harness disconnection
Available OK: normal
Unavailable NG: harness disconnection
Unavailable OK: normal
Available NG: harness short-circuited with GND
Available OK: normal
Unavailable NG: harness disconnection
Unavailable OK: normal
NG: harness short-circuited with another
Available
wiring
• Replace the harness.
• Replace the accelerator sensor.
Replace E-ECU.
• Replace the harness.
• Replace the accelerator sensor.
FAILURE DIAGNOSIS
Status
Action
1-143