Specific Safety Rules; Specifications - Milwaukee 4262-1 Operator's Manual

SPECIFIC SAFETY RULES

• When working overhead or on a vertical sur-
face, always use safety chain. Mounting can
release. (See "Safety Chain" under "Operation)
• Clean the surface before attaching the drill
stand to the work surface. Paint, rust, scale, or
uneven surfaces decrease the holding strength
or the magnet. Chips, burrs, dirt and other foreign
matter on the surface of the magnetic base will
also decrease holding power.
• Do not attach magnetic base to nonmagnetic
grades of stainless steel. The magnetic base
will not hold. The electro magnetic drill press
attaches magnetically to any ferrous metal. It is
designed for use on 1/2 inch or thicker ferrous
stock. Holding power will decrease on thinner
stock. A back up plate must be used (See "Backing
Plate" under "Operation").
• Wet connections are shock hazards. Prevent
cutting fl uid from traveling along the cord and
contacting the outlet, extension cord connections
or tool plug.
• If the plug or connections get wet, turn power
off to the outlet before unplugging the tool.
• Use clamps or other practical way to secure
and support the workpiece to a stable platform.
Holding the work by hand or against your body is
unstable and may lead to loss of control.
Drill
Motor
Cat. No. Speed
4253-1 • --
4262-1 --
4292-1 HIGH
- LOW
4297-1 HIGH
- LOW
M.T. - Internal Morse Taper Socket
• - 5/8" -11 or 1/2" -13 taps not recommended
**- Requires use of 3/4" shank arbor, Cat. No. 49-57-0030
* - Requires use of #3 MT Arbor, Cat. No. 49-57-0010 or 49-57-0014

SPECIFICATIONS

No
Volts Load
AC Amps RPM
120 6.2 600
120 11.5 350
120 11.5 750
- - 375
120 11.5 500
- - 250
• Use only accessories that are recommended by
the manufacturer for your model. Accessories
that may be suitable for one tool, may become
hazardous when used on another tool.
• Maintain labels and nameplates. These carry
important information. If unreadable or missing,
contact a MILWAUKEE service facility for a free
replacement.
• WARNING: Some dust created by power sanding,
sawing, grinding, drilling, and other construction
activities contains chemicals known to cause
cancer, birth defects or other reproductive harm.
Some examples of these chemicals are:
• lead from lead-based paint
• crystalline silica from bricks and cement and other
masonry products, and
• arsenic and chromium from chemically-treated
lumber.
Your risk from these exposures varies, depending
on how often you do this type of work. To reduce
your exposure to these chemicals: work in a well
ventilated area, and work with approved safety
equipment, such as those dust masks that are spe-
cially designed to fi lter out microscopic particles.
Maximum Recommended Capacity
Chuck
or Taper Drill
1/2" Chuck 5/8"
3/4" Chuck 1-3/8"
No. 3 M.T. 3/4"
- 1-1/4"
No. 3 M.T. 1-1/8"
- 1-1/2"
3
Fine Coarse
Thread Thread
Tap Tap
5/8" - 18 3/8" - 16
1" - 14 7/8" - 9
- -
1" - 14 7/8" - 9
- -
1" - 14 1" - 8
Steel
Hawg™
Cutters
-
4" **
2" *
4" *
3" *
5" *