Treatment Screens - ResMed Flow Generator VPAP Adapt SV User Manual

Servicing Menu
This menu displays the following information:
SN—the flow generator's serial number
•
PCB—the flow generator's PCB number (PCB—printed circuit board)
•
SW—the version of software currently installed on the flow generator.
•

Treatment Screens

There are three Treatment screens displayed in the VPAP Adapt SV LCD. The
LCD will display the Treatment screens when treatment commences, and during
treatment if no key is pressed for 20 minutes.
Press the Right key to move from a Treatment screen to the Standby screen.
If an alarm is triggered while you are in the Treatment screens, the arrow will
flash. Press the Down key until you reach the alarm message.
Scroll through the screens in the usual way, using the Up/Down key.
Treatment mode
Figure 16: Treatment Screen 1
Figure 17: Treatment Screen 2
Minute ventilation
Figure 18: Treatment Screen 3
Note: TARG is not a relevant parameter in CPAP mode.
24
Press the QuickView key at any point within a menu to display
Treatment Screen 1. You can return to your original screen if you press
the QuickView key again within 20 minutes.
Pressure
ASV 5.0--15.0
exit
Leak Respiratory rate
LK:18L/min RR:12
VT: 428
Tidal volume
Target ventilation
MV:6.2 TARG:5.8
exit