Control Panel; Remote Control; Indicator Lights - Haier HPP10XCT Installation And User Manual

UP AND DOWN ARROW BUTTONS
E
To Set the Temperature:
The temperature can be set between 62ºF and 86º F
(17ºC and 30º C) when the air conditioner is in Cool
mode.
1. Press the Mode button until the Cool mode is selected.
2. Press the Up Arrow or Down Arrow buttons to
select the Temperature.
NOTE: The temperature cannot be set when the air
conditioner is in either Fan or Dry mode.
MODE BUTTON
F
Press the Mode button to toggle among the three
operating modes. The corresponding indicator will
illuminate.
Cool – Cools the room to the set temperature.
Dehum – Reduces the humidity in the room
Fan – Circulates the air in the room without cooling
POWER BUTTON
G
Turns ON/OFF power to the air conditioner.
NOTE: Turning o power by pressing the Power button
does NOT disconnect the appliance from the power
supply.
•
Press the Power button. The Power indicator will
illuminate.

REMOTE CONTROL

A
1. Insert the two batteries (provided).
2. Aim the remote control at the signal receiver on the
control panel to operate the air conditioner.
SLEEP BUTTON
A
Increases the set temperature by 2ºF (1ºC) after
2-hours, and then increases the temperature by an
additional 2ºF (1ºC) after another 2-hours.
NOTE: The fan will operate at Low speed and cannot
Press the Sleep button to enter Sleep mode. The
Sleep indicator will illuminate.
To Cancel Sleep Mode:
•
Press the Sleep button or the Mode button (Cool, Fan
or Dry) on the remote control.
ºC/ºF BUTTON
B
•
Press the ºC/ºF button to toggle between displaying
the temperature in degrees Fahrenheit or degrees
Celsius. The corresponding indicator will illuminate.

INDICATOR LIGHTS

Timer High Low
Illuminate to indicate the selected mode, speed or
condition.
WATER FULL
A
The Water Full indicator illuminates, when the internal
conditioner will turn o automatically. To drain the water
tank, see "Air Conditioner Care" for instructions.
8
B
Water Full Cool Fan Dehum Sleep
A
POWER