Toshiba Q9 True Torque Control2 Adjustable Speed Drive Quick Start Manual page 30

LB
1 to 2 = Sink (*)
2 to 3 = Source
1 to 2 = Sys. Supplied (*)
2 to 3 = Ext. Supplied
SW301
V/I Switch (*I)
*
= Default Setting
20
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
assignments for this output terminal are listed in the Q9 ASD Installation and Operation Manual (See
F005 and F681).
FLA — A normally open contact that, under a user-defined condition, connects to FLC.
FLB — A normally closed contact that, under a user-defined condition, opens the FLB-to-FLC
connection.
FLC — FLC is the common leg of a single-pole double-throw form C relay. The FL relay is the Fault
Relay by default, but may be programmed to any of the selections listed in the Q9 ASD Installation
and Operation Manual (See F132 and
Note: The FLA, FLB, and FLC contacts are rated at 2A/120 VAC and 2A/30 VDC.
Figure 8.FLA, FLB, and FLC Switching Contacts Shown in the Normal Operating Condition.
Note: The relay is shown in the normal operating
condition. During a faulted condition the relay
connection is FLC-to-FLA.
Figure 9. Terminal Board.
CAUTION
J100
J101
(24 V)
TB1
TB2
TB3
TB4
See Figure 20 on pg. 22
See the section titled Terminal Descriptions on pg. 18
See the section titled Cable/Terminal Specifications on pg. 58
terminal sizes and torque specifications when making Terminal Board connections.
Figure 8).
Sink Source TB1 TB2 TB3 TB4
Ensure that the ground screw is securely
in place to prevent arcing, intermittent
operation, or system failure.
SW200
Half/Full Dupl ex(*) Swi tch
S4
RS485 4-Wire Communication
for more information on the Terminal Board connections.
for terminal descriptions.
for information on the proper cable/
Q9 ASD Quick Start Guide