Calibration; 6.10 Communications - Instrument Emulation; 6.11 Specification; 6.12 Return Goods/Material Procedure - GE PACE5000 User Manual

PACE Pressure Controller User Manual
6.9

Calibration

The calibration menu provides facilities for programming settings for maintenance as
follows:
Note: A PIN protects the Calibration menu against unauthorised use. Each instrument, on
delivery, contains the factory set PIN (4321). To continue protecting the supervisor set-
up menu, the PIN should be changed as soon as possible.
+ve source zero
-ve source zero
sensor correction
valve correction
source PDCR correction three-point calibration of both source pressure sensors
screen calibration
Time & Date
Change PIN

6.10 Communications - Instrument Emulation

(Ref: K0469 - PACE Communications Manual - Instrument Emulation).

6.11 Specification

(Ref: PACE Module Pressure Controller data sheet).
Note: Data sheet 920-561 is contained in the CD shipped with the product.

6.12 Return Goods/Material Procedure

If the unit requires calibration or is unserviceable return it to the nearest GE Service Centre
listed at www.gemeasurement.com.
Contact the Service Department, by 'phone, fax or E-mail to obtain a Return Goods
Authorisation (RGA) (Worldwide excluding USA).
In the USA obtain a Return Material Authorization [RMA].
• Product (i.e. PACE5000)
• Serial number
• Details of defect/work to be undertaken
• Calibration traceability requirements
• Operating conditions
[EN] English
Selects the range for a three-point calibration routine.
Sets instrument clock and calendar.
Changes the Calibration PIN. Enter the existing PIN, the new PIN and
confirmation of the new PIN. Should this new PIN become lost it can
only be reset by returning the instrument to a GE service centre.
6 - 41 K0443 Revision A