Getting Started; Cancel The Demonstration; Set The Clock And Date; Set The Basic Settings - JVC KD-R691 Instruction Manual

GETTING STARTED

For key layout on the faceplate, see page 3 or page 4.
1

Cancel the demonstration

When you turn on the power for the first time (or after you reset the unit),
the display shows:
KD-R691/KD-R491:
"CANCEL DEMO" "PRESS ENTER"
1
Press .
[YES] is selected for the initial setup.
2
Press again.
"DEMO OFF" appears.
KD-R499/KD-R494/KD-R492:
"CANCEL DEMO" "PRESS" "VOLUME KNOB"
1 Press the volume knob.
[YES] is selected for the initial setup.
2 Press the volume knob again.
"DEMO OFF" appears.
2

Set the clock and date

1
Press and hold .
2
Perform 'select an item ( 3 or 4)' operation to select [CLOCK].
3
Perform 'select an item ( 3 or 4)' operation to adjust the clock.
[CLOCK ADJUST] set the hour and minute
[12H] or [24H]
4
Perform 'select an item ( 3 or 4)' operation to set the date.
[DATE SET] set the day, month and year
5
Press to exit.
To return to the previous setting item, press
[CLOCK FORMAT]
.
3

Set the basic settings

1
Press and hold .
2
Perform 'select an item ( 3 or 4)' operation to select an
item (see the following table).
3 2
Repeat step until the desired item is selected or activated.
4
Press to exit.
To return to the previous setting item, press
SYSTEM
KEY BEEP ON: Activates the keypress tone. ; OFF: Deactivates.
SOURCE SELECT
AM SRC *
ON: Enables AM in source selection. ; OFF: Disables. ( 6)
BUILT-IN AUX * ON: Enables AUX in source selection. ; OFF: Disables. ( 8)
F/W UPDATE
UPDATE SYSTEM
F/W UP xxxx YES: Starts upgrading the firmware. ; NO: Cancels (upgrading is not
activated).
For details on how to update the firmware, see:
<http://www.jvc.net/cs/car/>.
* Not displayed when the corresponding source is selected.
.
Default: XX
5
ENGLISH