Page 1
18 VOLT CORDLESS CHAINSAW OWNER’S MANUAL Polesaw Model Chain Saw Model BPS188A (8"/20.3 cm) BS188A (8"/20.3 cm) IMPORTANT: Read and understand this manual before assembling or operating this saw. Improper use of saw can cause severe injury. Keep this manual for future reference.
Page 2
DO NOT RETURN PRODUCT TO STORE. CALL 1-800-626-2237 FOR TECHNICAL ASSISTANCE For more information, visit www.remingtonpowertools.com This manual is your guide to safe and proper operation of the saw. SAVE THESE INSTRUCTIONS. Keep your purchase receipt for warranty coverage. NO DEVUELVA EL PRODUCTO A LA TIENDA Para más información, www.remingtonpowertools.com PARA AYUDA TÉCNICA LLAME AL 1-800-626-2237 Este manual es su guía para utilizar esta sierra eléctrica de...
INTRODUCTION Your Remington Cordless Polesaw and Cordless Chainsaw may have been purchased together (as a 2-in-1 polesaw/chainsaw) or seperate (chainsaw only). If the chainsaw was purchased separately, the pole is available as an accessory and may be purchased by visiting the "On-Line Outlet" at www.remingtonpowertools.com.
IMPORTANT SAFETY INFORMATION READ ALL INSTRUCTIONS. Make sure you read and under- stand all instructions in Important Safety Information. Improper use of this chain saw can cause severe injury or death from fi re, electrical shock, body contact with moving chain, or falling wood.
IMPORTANT SAFETY INFORMATION Carrying Saw Carry saw from one place to another • with saw stopped • with fi nger off trigger • with guide bar and chain to rear • Chain saw - by holding front handle (never use hand guard as handle) •...
IMPORTANT SAFETY INFORMATION General Maintenance Maintain saw with care. • Never expose saw to rain. • Keep chain sharp, clean, and lu- bricated for better and safer performance. • Follow steps outlined in this manual to sharpen chain. • Keep handles dry, clean, and free of oil and grease.
CHAIN SAW TERMS AND DEFINITIONS Bucking Process of cutting a felled tree or log into lengths. Felling Process of cutting down a tree. Felling Cut Final cut when felling a tree. Make this cut on opposite side of tree from notching cut.
Do not expose charger to rain or snow. Use of an attachment not recommended or sold by Remington brand may result in a risk of fi re, electric shock, or injury to persons. To reduce risk of damage to electric plug and cord, pull by plug rather than cord when disconnecting charger.
RECHARGEABLE BATTERY CHARGING BATTERY The battery pack is not fully charged at the factory. Before attempting to charge the battery pack, thoroughly read all Safety Instructions. The charger is designed to use standard household 120 volt 60 Hz power. Plug cord from charger into charger base.
Figure 7). Note: Fully charge battery before using for fi rst time. See Charging Battery. NOTE: Your Remington Cordless Polesaw and Cordless Chainsaw may have been purchased together (as a 2-in-1 polesaw/ chainsaw) or seperate (chainsaw only). If the chainsaw was purchased separately, the pole is available as an accessory and may be purchased by visiting the "On-Line Outlet"...
CHAIN SAW INFORMATION Do not over-tension chain. Over-ten- sioning will cause excessive wear and will reduce the life of the guide bar and chain. Over-tensioning also re- duces the amount of cuts per battery charge. After chain tension is correct, tighten guide bar nuts fi...
CHAIN SAW INFORMATION Felling Procedure A) Felling Notch A properly placed felling notch will deter- mine direction tree will fall. Place felling notch on side of tree in direction you want tree to fall (see Figure 15). Follow directions below to create a felling notch.
CHAIN SAW INFORMATION BUCKING A LOG WARNING: Avoid kickback. Kickback can result in severe injury or death. See Kickback to avoid risk of kickback. WARNING: • If on slope, make sure log will not roll down hill. Secure log by using wooden stakes. Drive wooden stakes into ground on downhill side of log.
Figure 26 - Assembled Battery onto Main Handle ADJUSTING POLE LENGTH The Remington brand polesaw has a tele- scoping pole assembly that will extend from 47 inches (fully retracted) to 83 inches (fully extended). A cam levered collet is used to hold the pole in position at any extended length.
CLEANING AND MAINTENANCE NOTICE: Below are instructions for servicing your chain saw. Any servicing not mentioned below should be done by an authorized service center. CLEANING SAW BODY WARNING: Remove battery from chain saw before servicing. Severe injury or death could oc- cur from body contact with mov- ing chain.
CLEANING AND MAINTENANCE Filing Cutter Depth Gauges The cutter depth gauge clearance is reduced as cutters are sharpened. After every second or third sharpening, reset cutter depth gauges. Place depth gauge tool (.025") fi rmly across top of two cutters. Make sure depth gauge enters slot in depth gauge tool (see Figure 34).
STORAGE If storing saw for more than 30 days, follow steps below. Remove battery from chain saw. Charge battery completely. Note: It could take up to 9 hours to complete- ly charge the battery. When battery is completely charged, remove from charger and put protec- tive cap on battery terminals.
TROUBLESHOOTING Note: For additional help, visit DESA Power Tools’ technical service web site at www.remingtonpowertools.com. WARNING: Remove battery from chain saw before adjusting saw chain tension. Severe injury or death could oc- cur from body contact with moving chain. OBSERVED FAULT Saw runs, but does not cut Saw does not cut unless heavily forced.
REMINGTON BRAND 18V CORDLESS POLESAW/CHAIN SAW Standard Warranty DESA Power Tools warrants this new product and any parts thereof to be free from defects in material and workmanship for a period of two (2) years from the date of fi rst purchase from an authorized dealer provided the product has been maintained and operated in accordance with DESA Power Tools’...
Page 21
Sierra de cadena INALÁMBRICA DE 18 VOLTIOS MANUAL PARA EL USUARIO Sierra de pértiga Sierra de cadena BPS188A (8"/20.3 cm) BS188A (8"/20.3 cm) IMPORTANTE: Lea cuidadosamente este manual antes de armar u operar esta sierra eléctrica. El uso indebido de la misma puede provocar graves lesiones.
Page 22
INTRODUCCIÓN Su sierra de pértiga y motosierra inalámbricas pudieron haberse comprado juntas (como una pértiga/motosierra 2 en 1) o por separado (sólo motosierra). Si la motosierra fue comprada por separado, la pértiga está disponible como un accesorio y se la puede comprar visitando “On-Line Outlet”...
INFORMACIÓN IMPORTANTE DE SEGURIDAD LEA TODAS LAS INSTRUCCIONES Asegúrese de leer y entender todas las indicaciones en Información Importante de Seguridad. El uso incorrecto de esta sierra de cadena puede causar lesiones serias o la muerte debido a incendio, electro- choque, contacto del cuerpo con una cadena en movmiento, o por madera que cae.
INFORMACIÓN IMPORTANTE DE SEGURIDAD Permanezca alerta Permanezca alerta. Utilice el sentido común. Sujete la sierra fi rmemente con ambas manos. Nunca utilice la sierra con una sola mano. Nunca utilice el protector de mano a manera de mango. Agarre la sierra de pértiga en forma segura.
INFORMACIÓN IMPORTANTE DE SEGURIDAD • Utilice la cadena y la barra de guía de contragolpe reducido suministra- dos con esta sierra. Reemplácelos exclusivamente con las cadenas y barras de guía enumeradas en este manual. • Nunca utilice cadenas romas (des- gastadas) o sueltas.
INFORMACIÓN IMPORTANTE DE SEGURIDAD PRECAUCIONES AL RECORTAR CON LA SIERRA DE PÉRTIGA Nunca se pare debajo de la rama que está recortando. Póngase siempre fuera de la trayectoria de los desechos que caen. Nunca se pare sobre una escalera ni ningún otro tipo de soporte in- estable mientras usa la sierra de pértiga.
IDENTIFICACIÓN DEL PRODUCTO SIERRA DE CADENA Protección Frontal de la Mano Mango Botón de Posterior desenganche del mango Cubierta de la rueda dentada Cabezal motorizado Botón de desenganche de la batería Batería SIERRA DE PÉRTIGA Bloqueo del gatillo Interruptor de Gatillo Mango Posterior...
TÉRMINOS Y DEFINICIONES DE LA SIERRA DE CADENA Barra de guía Barra de metal que se extiende hacia adelante desde el cabezal. La barra de guía sostiene y guía la cadena serrada. Barra de guía de contragolpe redu- cido Barra de guía que reduce las proba- bilidades de contragolpe.
No exponga el cargador a la lluvia o nieve. El uso de un accesorio no recomenda- do o vendido por la marca Remington puede representar un riesgo de incen- dio, sacudida eléctrica o lesiones a personas. PRECAUCIÓN: Para reducir el riesgo de una lesión, cargue sólo...
BATERÍA RECARGABLE CARGA DE LA BATERÍA El paquete de baterías no viene completamente cargado de fá- brica. Antes de intentar cargar el paquete de baterías, lea comple- tamente todas las instrucciones de seguridad. El cargador está diseñado para usar energía casera estándar de 120 voltios y 60 Hz.
INFORMACIÓN SOBRE LA SIERRA DE CADENA ENSAMBLADO DE LA SIERRA DE CADENA ADVERTENCIA: Los bordes de corte de la cadena son afi lados. Al manipular la cadena, utilice guan- tes de protección. Alinee el reborde del cabezal motriz de la motosierra con la ranura del mango principal (vea la fi...
INFORMACIÓN SOBRE LA SIERRA DE CADENA AJUSTE DE TENSIÓN DE LA CADENA SERRADA Afl oje las tuercas de la barra guía an- tes de regular la cadena (vea la fi gura Tuercas de la barra de guía Figura 9 - Afl oje las tuercas de la barra guía.
INFORMACIÓN SOBRE LA SIERRA DE CADENA TALA DE UN ÁRBOL (Derribamiento de un árbol) ADVERTENCIA: • Evite los contragolpes, ya que pueden provocar lesi- ones graves y aun la muer- te. Para evitar el riesgo de contragolpe, vea la sección Contragolpes.
INFORMACIÓN SOBRE LA SIERRA DE CADENA DESMEMBRAMIENTO DE UN ÁRBOL ADVERTENCIA: Evite los con- tragolpes. Éstos pueden provocar lesiones graves y aun la muerte. Para evitar el riesgo de contragolpes, lea la sección Contragolpes. ADVERTENCIA: Proceda con sumo cuidado al cortar ramas o vástagos de árboles que se encuen- tran en tensión.
INFORMACIÓN SOBRE LA SIERRA DE CADENA PODA DE UN ÁRBOL ADVERTENCIA: Evite los contragolpes. Éstos pueden provocar lesiones graves y aun la muerte. Para evitar el riesgo de contragolpes, lea la sección Contragolpes en la página 24. ADVERTENCIA: No utilice la sier- ra eléctrica mientras se encuentre •...
INFORMACIÓN SOBRE LA SIERRA DE PÉRTIGA ENSAMBLADO DE LA SIERRA DE PÉRTIGA ADVERTENCIA: Los bor- des de corte de la cadena son afi lados. Al manipular la cadena, utilice guantes de protección. Retire la batería de la motosierra. Para separar el mango principal del cabezal motriz de la motosierra pre- sione ambos botones de desenganche del mango principal y separe (vea la...
INFORMACIÓN SOBRE LA SIERRA DE PÉRTIGA REGULACIÓN DE LA LONGITUD DE LA PÉRTIGA La sierra de pértiga marca Remington tienen el conjunto pértiga telescópica que se extien- de desde 47 pulgadas (totalmente retraída) hasta 83 pulgadas (totalmente extendida). Para mantener la pértiga en posición en cualquier parte de su longitud se usa un anillo que sujeta con leva.
LIMPIEZA Y MANTENIMIENTO AVISO: A continuación encontrará instrucciones para la realización de tareas de servicio en su sierra eléctrica. Toda tarea de servicio que no se encuentre incluida a continua- ción debe realizarse en un centro de servicios autorizado. LIMPIEZA DEL CABEZAL ADVERTENCIA: Retire la ba- tería de la motosierra antes de regular la tensión de la cadena de...
LIMPIEZA Y MANTENIMIENTO Luego de afi lar cada elemento de corte, mueva la cadena hacia adel- ante para afi lar el siguiente elemento. Afi le todos los elementos de corte a un lado de la cadena. Diríjase al otro lado de la cadena y repita el mismo proceso.
ALMACENAMIENTO If storing saw for more than 30 days, follow steps below. Quite la batería de la sierra de cadena. Cargue la batería por completo. Nota: Puede llevar hast 9 horas poara car- gar por completo la batería. Cuando la batería esté cargada por completo, quítela del cargador y pon- ga la tapa protectora sobre los termi- nales de la batería.
DIAGNÓSTICO Y RESOLUCIÓN DE PROBLEMAS Nota: Para obtener más ayuda, visite el sitio Web de servicio técnico DESA Power Tools, www.remingtonpower- tools.com. ADVERTENCIA: Retire la batería de la motosierra antes de dar servicio. Puede ocurrir una grave lesión o la muerte si el cuerpo entra en contacto con la cadena en movimiento.
SIERRA DE PÉRTIGA/DE CADENA INALÁMBRICA DE 18V DE MARCA REMINGTON Garantía Estándar DESA Power Tools garantiza, por un período de dos (2) años a partir de la fecha de la primera compra en un distribuidor autorizado y a condición que el producto ha sido mantenido y operado siguiendo las advertencias e instrucciones de DESA Power Tools, que este nuevo producto y cualquiera de sus partes están sin defectos en material o mano de obra.