EnGenius ETR9360 Quick Installation Manual

Wireless n pocket router

Hide thumbs Also See for ETR9360:

Download this manual See also: User Manual

Please ensure your PC or Laptop support wireless network and is turned on and

enabled.

Note: ETR9360 is pure AP by default; therefore you should access the device over your wireless

network.

Slide open your battery cover and insert the battery as shown below.

Ensure the on/off switch is flipped to O and plug in the charger as shown.

Check the battery level. You are advised to charge the battery to its full level before

start using the device.

To power on the device, please flip the switch to I . When system is completely

powered on wireless LED will start blinking.

Note1: You are advised to flip on/off switch to O before charging the battery. It takes about 1~2 hours to

charge the battery.

Wireless N Pocket Router ETR9360

Quick Installation Guide

Page 1 Please ensure your PC or Laptop support wireless network and is turned on and enabled. Note: ETR9360 is pure AP by default; therefore you should access the device over your wireless network. Slide open your battery cover and insert the battery as shown below.
Page 2 Wireless N Pocket Router ETR9360 Quick Installation Guide On your PC/Laptop, scan the surrounding APs using your wireless utility (eg: Windows Zero Config). Locate the AP SSID EnGeniusXXXXXX and connect to it. Note2: XXXXXX is the WLAN MAC address which you can find on the back label inside your battery case.