Horn Alert/P.a. Relay Unit (Kap-2); Installing The Kap-2 Unit In The Transceiver - Kenwood NX-5700 Service Manual

2.3.2 Horn Alert/P.A. Relay Unit (KAP-2: Option)
The Horn alert (max. 2A drive), Public address and External
speaker function are enabled by installing the KAP-2 in the trans-
ceiver.
2.3.2.1

Installing the KAP-2 unit in the transceiver

(The kit A is not used in the KAP-2 accessories)
(1) Remove the cabinet, top packing and shielding plate of the
transceiver.
(2) Set the KAP-2 relay unit jumper pins according to the pur-
pose of use.
(3) Remove the 6-pin jumper connector inserted in the TXRX
unit (A/2) connector (CN910). <1>
<1>
CN910
(4) Insert one side of the lead wire with connector (E37-1114-
05) into the relay unit connector (CN3) <2> and the other
side into the TX-RX unit (A/2) connector (CN910) <3>
<2>
CN910
1-14 (No.RA020<Rev.002>)
Fig.2-1
E37-1114-05
CN3
<3>
Fig.2-2
(5) Place the relay unit at the position shown in Figure 2-2 and
secure it to the chassis with a screw.
(6) Remove the cap on the rear of the chassis by pushing it
from the inside with your finger. <4>
Fig.2-3
(7) Pass the 6-pin connector of the cable (E37-1113-25)
through the chassis hole <5> and insert the bush into the
shassis hole.
(8) Rotate the bush of the cable 90 degrees counterclockwise
as viewed from the rear of the chassis. <6>
(9) Insert the 6-pin connector of the cable into the connector
(CN2) of the KAP-2 relay unit. <7>
Note:
You must setup using the KPG-D1/D1N.
<6> <6> <6>
E37-1113-25
Fig.2-4
<4>
<5>
CN2
<7>