KTM 125 SX 2018 Owner's Manual page 49

11 SERVICE WORK ON THE CHASSIS
–
Position the swingarm and mount the swingarm pivot.
Info
Pay attention to flat area
–
Mount and tighten nut
Guideline
Nut, swingarm pivot
K00862-10
–
Mount the chain.
–
Connect the chain with the connecting link.
Guideline
The closed side of the chain joint lock must face in the direction of travel.
M01149-01
–
Position the foot brake cylinder.
Push rod
The dust boot is correctly positioned.
–
Mount and tighten screws
Guideline
Remaining screws, chassis
K00863-10
–
Position the angle lever and linkage lever.
–
Mount and tighten fitting
Guideline
Nut, linkage lever to angle lever
Info
Pay attention to flat area
–
Mount and tighten screw
K00864-10
Guideline
Screw, bottom shock
absorber
Info
Raise the wheel slightly to be able to mount the screw more easily.
–
Position the frame protectors on the left and right.
–
Mount and tighten screws
Guideline
Screw, frame protector
–
Mount the cable tie(s).
K00861-11
Finishing work
–
Remove the motorcycle from the lift stand. (
A
.
2
.
3 engages in the foot brake cylinder.
4
.
5
.
B .
6
.
M10
7 with the washers and mount and tighten screws
M16x1.5 100 Nm
(73.8 lbf ft)
M6 10 Nm (7.4 lbf ft)
M14x1.5 80 Nm (59 lbf ft)
60 Nm Loctite
(44.3 lbf ft)
M5 3 Nm (2.2 lbf ft)
p. 38)
47
® 2701™
8 .