Mounting The Device; Mounting The Device On A Din Rail; Dimension Drawings - Siemens RUGGEDCOM RS900 Installation Manual

RUGGEDCOM RS900
Installation Guide
NOTE
For further details of the device's compliance with Class I, Division 2, Zone 2 standards, refer to
Section 6.1, "Approvals"
Sample Hazardous Location Label
The following is an example of the RUGGEDCOM RS900 hazardous location label:
Figure 2: Compliance Label (Example)
Section 2.3

Mounting the Device

The RUGGEDCOM RS900 is designed for maximum mounting and display flexibility. It can be equipped with
adapters that allow it to be installed on a 35 mm (1.4 in) DIN rail or affixed to a panel.
NOTE
For detailed dimensions of the device with either DIN rail or panel hardware installed, refer to
Chapter 5, Dimension Drawings
CONTENTS
• Section 2.3.1, "Mounting the Device on a DIN Rail"
• Section 2.3.2, "Mounting the Device to a Panel"
Section 2.3.1

Mounting the Device on a DIN Rail

For DIN rail installations, the RS900 can be equipped with a DIN rail bracket pre-installed on the back of the
chassis. The bracket allows the device to be slid onto a standard 35 mm (1.4 in) DIN rail.
To mount the device to a DIN rail, do the following:
1. Align the slot in the bracket with the DIN rail.
Mounting the Device
.
.
Chapter 2
Installing the Device
7