Chapter 12: SPI Serial Flash
Configuring from SPI Flash
To configure the FPGA from SPI Flash, the FPGA mode select pins must be set
appropriately and the SPI Flash must contain a valid configuration image.
Select SPI Mode using Jumper Settings
Remove the top jumper, insert the bottom two as shown
DONE Pin LED
Lights up when FPGA successfully configured
Setting the FPGA Mode Select Pins
Set the FPGA configuration mode pins for SPI mode, as shown in
of the configuration mode jumpers (J30) appears in
90
Jumper JP8 (XSPI)
When programming SPI Flash using XSPI
utility, insert jumper to hold PROG_B pin Low
Figure 12-3: Configuration Options for SPI Mode
Figure 12-4: Set Mode Pins for SPI Mode
www.xilinx.com
Header J12 (XSPI Programming)
PROG_B Push Button Switch
Press and release to restart configuration
Figure
12-3.
M0
M1
M2
J30
UG230_c15_03_030206
Spartan-3E Starter Kit Board User Guide
R
Jumper J11
UG230_c15_02_030906
Figure
12-4. The location
UG230 (v1.0) March 9, 2006