Table of Contents
Advertisement
DeviceNet add-on module
4.1.2 Quick set-up
4. Commissioning
The MAC ID can be set from the bus or via the keypad display.
To change (or view) the DeviceNet settings from the keypad display.
1.
Press and hold [Top key]
( NOTE: For "View" mode only, skip steps 2 & 3)
2.
Type in password (1000) by pressing [Change key]
[Lock key]
. The display shows "Edit mode" for two seconds
3.
The display now shows/displays "Basic settings"
4.
Press [Forward key]
5.
Press [Lock key]
6.
You can now cycle through all the DeviceNet settings by pressing [Forward key]
7.
Select "MACID [0..63]"
8.
Type in the address with the [Change key]
9.
Lock the setting with the [Lock key]
10. Select "Baud rate [0..2]"
11. Select the desired baud rate with the [Change key]
12. Lock the setting with the [Lock key]
13. Select "Assembly selection"
14. Select the desired "Polled I/O data size" with the [Change key]
15. Lock the setting with the [Lock key]
16. Select "Update rate"
17. Select the desired PDO update rate with the [Change key]
18. Lock the settings with the [Lock key]
19. Press [Top key]
for two seconds to return to 1
SFIDK.PS.023.C2.02
for two seconds.
until you reach the "DeviceNet module" menu item
and [Next key]
two times, and then press
9
Advertisement
Table of Contents
