Table of Contents
Advertisement
E
9
K
G-CODE TIMER RECORDING
PROGRAMMING
Programming
on the VCR display
You can programme
or confirm a G-Code
timer recording
on the VCR disday
even if
the TV is turned off.
1
Press the WXIDE
button
9 bars (-) will appear on the display,
If 6 timer recordings
have already been
set, the 9 bars (-) are not displayed.
Please refer to "Confirmation"
and
"Canceling"
on page15.
z
Using the numeric buttons, enter the
Code number for the programme
you
want to record
ExamP/e:
Enter the Code number 489135
mm
If
you entered a wrong number, press the
CLEAR button to delete it, then enter the
correct number.
3
Press the OK button,
The programmed
recording
programme
position number and recording
on time
are displayed.
Notes:
If the programme
position
number
(PR) displays
"__,,.
Enter the programme
position number the TV
station has been preset to.
That setting will be memorized
and set the next
time the same TV station is selected.
a
When allthesettings
areas desired,
press the OK button.
You can programme
another recording
by
repeating steps 2 to 4.
s
Insert a videocassette
with
erasure-prevention
tab.
Make
sure the tape is longer than the total
recording time.
6
Press the G-CODE button,
The timer indicator (~) will light on the
VCR display
and the VCR goes
into timer
recording
stand-by
mode.
Additional settings
After pressing the OK button in step 3.
Daily/Weekly recording
Press the MENUITV button repeatedly
to
select:
c' M -F": for daily recording
(Monday
through
Friday)
"WK":
for weekly
recording
(the same
programme
every week)
No
display:
for one time recording
Note:
Daily recording
starting on a Saturday or Sunday
will not be possible.
Recording tape speed setting
Press the TAPE SPEED button repeatedly
to
display the desired tape speed.
No display:
Standard Play mode
LP: Long Play mode
Changing the off time
Each press of the
(CH+ or CH-) button will
change the recording
off time by units of 10
minutes,
New Zealand only
Note on sky decoders and recording
1.
2.
L
There are at present two types of sky
decoders
available
in New Zealand,
Base
Band
Decoder
(no remote control
supplied,
older type),
You cannot successfully
record G-Code
programmed
using this type of decoder.
(Unless your video is modified
internally first.)
Contact Sky TV for details.
IRD Decoder
(supplied
with Sky Remote and
with UHF output).
This decoder allows you to programme
recordings
using the G-Code function, You
can use the Sky CODE NUMBERS to record
Sky TV programmed
with your VCR. However,
please note the following
limitations.
(a)
The Sky CODE NUMBERS used with the
VCR can not change the channels on the
Sky Decoder,
This means you must first preselect the
Sky channel you want to record (movies,
sport, news)
(b)
The VCR will then turn on and record the
programme
position which has been set
for Sky, (e.g. programme
position "4),
The Sky channel you record (movies,
sport, news) will depend on which
channel the decoder was left on.
(c) Remember the first time you use a Sky
CODE NUMBER, the programme
position
number
("PR")
on the video needs to be
set the same for all three Sky channels.
This will depend on the programme
position number you allocated for Sky in the
set up. ie programme
position number "4.
Advertisement
Table of Contents
