Reebok RBBE2057.0 User Manual page 11

13. Slide the Lock Frame (11) onto the notched
bracket on the Leg Frame (10), and insert the
lower end of the Lock Frame into the slot in
the Foot Plate (19). Attach the Lock Frame
with an M10 x 75mm Button Bolt (57), two
M10 Washers (68), two 16mm Spacers (46),
and an M10 Nylon Locknut (65) as shown.
Make sure that the Button Bolt is inserted
through the hole in the lower end of the
Lock Frame.
See step 12. Tighten the four M4 x 25mm
Screws (60).
Pull the Ankle Lock Assembly (33) upward
and pivot the Lock Frame (11) over the indi-
cated notch in the bracket on the Leg Frame
(10). Release the Lock Handle and engage
the Lock Frame into the notch.
See the inset drawing. Attach an M8 x
16mm Button Bolt (61) and an M8 Nylon
Locknut (72) to the hole in the end of the
bracket on the Leg Frame (10).
14. Identify the two Rear Ankle Braces (34), which
have holes in the indicated locations.
Slide a Rear Ankle Brace (34) onto the Ankle
Brace Tube (18). Attach the Rear Ankle Brace
with two M4 x 15mm Screws (58). Make sure
that the Screws are tightened into the indi-
cated holes in the Ankle Brace Tube. Next,
press a 19mm Round Cap (45) into the Ankle
Brace Tube, and attach the Round Cap with
an M4 x 15mm Screw (58).
Attach the other Rear Ankle Brace (34) to
the Ankle Brace Tube (18) in the same way.
15. Slide a Front Ankle Brace (22) onto the round
tube on the Lock Frame (11). Next, press a
19mm Round Cap (45) into the round tube,
and attach the Round Cap with an M4 x 15mm
Screw (58).
Attach the other Front Ankle Brace (22) in
the same way.
13
33
11
Slot
19
57
68 46
72
61
10
14
34
45
58
Holes
58
15
11
22
45
58
11
10
Notch
46
68
65
34
18
Holes
22