Toshiba FT-8259 Service Manual page 15

3. The base and handset cannot be connected.
Check whether the base
is able to set in the test
mode 1.
OK
Check the TX POWER
and the TX FREQUENCY
on the base unit.
OK
Set the base in the test
mode 3, check whether
deviation of the TX data
is app. 8 kHz Dev.
OK
Set the base in the test
mode 8, 903.002467
MHz (250 Hz ±8 kHz
Dev.) 1mV output signal
from RF jack is applied.
Can the INTCOM LED
be lighted?
OK
Check whether the
handset is able to set in
the test mode 1.
OK
Check the TX POWER
and the TX FREQUENCY
on the handset unit.
OK
A
NG Check IC14 and its
peripheral circuit.
NG
Check base RF unit.
Check whether there is a
NG
250 Hz data waveform at
"MOD" of RF unit.
OK
Check base RF unit.
NG Check whether there is a
250 Hz data waveform at
pin 9 of IC181.
OK
Check whether there is a
250 Hz data waveform at
the Q3 collector.
OK
Check whether there is a
250 Hz data waveform at
pin 54 of IC14.
OK
Check IC14 and its
peripheral circuit.
NG Check IC603 and its
peripheral circuit.
NG
Check handset RF unit.
Check RT2, R69, R70,
NG
R71, R72, R115, C56
and C84.
NG Check IC181, Q181 and
their peripheral circuit.
OK
NG Check RT1, Q3 and their
peripheral circuit.
NG Check R261, IC4 and
their peripheral circuit.
16
NG
Check base RF unit.