Panasonic Toughbook CF-07 Series Reference Manual page 43

Dealing with Problems (Advanced)
Connecting Peripherals
A USB device does not
work
It is not easy to hear of
the microphone sound.
Disk Operations
Cannot read/write to a
disk
Unable to write to a disk
How to format a disk is
unclear
Unable to read/write to
the hard disk
When the previous item
is not the cause
Trouble has occurred
with the disc
The access lamp does
not light
Cannot play disc or read
data from it
Cannot eject disc
A blue background ap-
pears on the screen with
the MPEG image
The CD-ROM drive vi-
brates a lot
Make sure a driver is installed.
Contact the manufacturer of the product.
1 Double click on the taskbar.
2 Select [Options] - [Properties].
3 Check [Playback], add the check mark for [Microphone], then select [OK].
4 Select [Options] - [Advanced Controls].
5 Select [Advanced] in [Microphone].
6 Add the check mark for [2. Microphone Boost] and select [Close].
7 Click in the top of right corner of the window.
Has the disk been correctly inserted?
Has the disk been correctly formatted?
Your disk content may be corrupted.
Is the disk write-protected?
Select [Format] in [My Computer] - [3 1/2 Floppy (A:)] - [File]. After confirming the
disk volume and format type, start formatting.
Your drive or file may not have been properly set.
Check to see if the hard disk is full. If it is full, delete unnecessary files.
Your hard disk content may be corrupted. Contact Panasonic Technical Support.
Try testing another drive or media.
You may need to clean the lens or disc.
Is the disc loaded on the tray correctly?
Is the disc bent, scratched, or dirty?
Is the computer powered on?
To remove a disc when the computer is powered off, insert a sharp object such as the
bent-out tip of a paper clip into the emergency hole. Pushing it completely to the end
will free the tray so that it can be pulled out.
Did you open the CD-ROM drive or remove the MPEG disc while it was operating?
Re-insert the MPEG disc and close the CD-ROM drive. Press Enter .
Is the disc bent labeled?
Set the [CD Drive Speed] to [Low] in the Setup Utility. (
Emergency Hole
page
43
33)