sure while shorfening the rod decreases lift
height and increases downward pressure.
REMOVING THE SNOWTHROWER
Remove the snowthrower by reversing the steps out-
lined in the Installation procedures. Please note the
following:
Install all pins and hairpin clips into appropriate hole
locations on hitch and snowthrower for storage.
NOTE: On mode/s equipped with electric lift,
change the electric lift wires leads (A and S,
Figure 26) back to their original position
when removing snowthrower so switch oper-
To avoid personal injury, use extreme care
hitch. Place lift lever fully rearward and
loosen eyebolt hardware (K & L, Figure 25)
before attempting to remove spring.
attachments. See Reverse Electric Lift
Wiring on page IO.
ADJUSTMENTS
NOTE: The following adjustments apply to the
A
WARNING
Before performing adjustments, stop the
engine and remove the key. Place tractor
and snowthrower on a level surface.
Engage the tractor parking brake. Wait for
all moving parts to stop.
Belt Adjustment
See Figure 27. Turn belt adjuster handje (C) until
trunnion (A) is located between the mart&shown.
NOTE: If trunnion cannot be p/aced between marks,
loosen capscrew (0) and reposition idlerpul-
. Electric Lift Motor Wires
Figure 27. Adjusting Belt Tension
A. Trunnion
B. Spring Tension Bracket
C. Handle
15
40" SNOWTHROWER
MARKS
D. Capscrew
E. Idler Pulley
F. Pivot Bracket
E