Gprs-Modem (Only R0011); Cp1 And Cp2 Interface; Cpa And Cpb Interface - ABB RTU560 Operation Manual

RTU560
Connections and Settings
Communication Unit 560CMD11
Serial Interface RS232C Mode
Pin Signal Input / Output
1 DCD
2 RxD
3 TxD
4 DTR
5 GND
7 RTS
8 CTS
Shield
Connected with housing
Table 2: Serial Interface RS232C Mode
The interfaces are available on the RJ45 connect-
ors and designed for RS485. The bus is terminat-
ed by a 1 kΩ resistor for the interfaces.

CP1 and CP2 Interface

At the CP1 and CP2 interfaces connected to an
USART (universal synchronous/asynchronous re-
ceiver/transmitter) different UART based protocol
types can be used.

CPA and CPB Interface

The settings have to be done by the RTUtil560
configuration tool.
At the CPA and CPB interfaces different UART
character based protocol types can be used.
560CMD11 R0011
The communication interface CPB has two differ-
ent functions:

UART character based protocols

GPRS-Modem-Interface
Both functions are mutually exclusive.
Doc.-No.: 1KGT 150 765 V005 1
Input
Input
RJ45 RJ45 RJ45
Output
Rx Rx
Output
Tx Tx
-
Output
Jack
Input

GPRS-Modem (only R0011)

The settings have to be done by the RTUtil560
configuration tool.
The 560CMD11 R0011 provides a radio interface
via an integrated Quad-Band GSM/GPRS mo-
dem. For communication via the GSM/GPRS mo-
dem a pluggable SIM-Card is necessary.
The SIM-Card socket is placed below the Com-
1 1 1
pactFlash socket.
8 8 8
The Quad-Band modem is designed for following
frequencies and GSM nets:

GSM 850MHz max. 2Watt transmitting
power

E-GSM 900MHz max. 2Watt transmitting
power

DCS 1800MHz max. 1Watt transmitting
power

PCS 1900MHz max. 1Watt transmitting
power
At the housing (see Fig. 10) an antenna or anten-
na cable can be connected via a 50Ω (high fre-
quency) SMA-RF-connector type.
Note:
Operating without a frequency tuned antenna can
be cause damage on the GPRS modem.
Following antennas are recommended:

560ANA01 bar (dipole) antenna
ABB number: 1KGT023600R0001

560ANA02 Wall-mount antenna connect-
ed by a 5mtr long coaxial cable
ABB number: 1KGT023700R0005

560ANA02 Wall-mount antenna connect-
ed by a 20mtr long coaxial cable
number: 1KGT023700R0020

ABB
2