RCA L26HD32D Owner's Manual page 38

Connections to other equipment
To connect an audio system
This connection allows you to use an audio amplifier and external speakers, and adjust the audio level using the
TV's remote control.
To control the audio, turn on the unit and the stereo amplifier, and turn off the unit's built-in speakers (see
"Turning off the built-in speakers" on page 24).
Rear of the unit
To connect the TV/DVD to a camcorder, or a TV Game
To playback from a camcorder, connect the camcorder to the unit as shown.
This unit can also be used as a display device for many video games. However, due to the wide variety of
signals generated by these devices and subsequent hook-up variations required, they have not all been
included in the suggested connection diagrams. You'll need to consult each component's Owner's Manual for
additional information.
Rear of the unit
To LINE 1 or LINE 2 VIDEO/AUDIO IN
To connect the TV/DVD to a PC (Personal Computer)
Before you connect this TV/DVD to your PC, change the adjustment of your PC's Resolution and Refresh rate
(60 Hz).
Connect one end of a (male to male) VGA cable to the video card of the computer and the other end to the VGA
connector PC MONITOR on the rear of the TV/DVD. Attach the connectors firmly with the screws on the plug. In
case of a Multimedia computer, connect the audio cord to the audio output of your Multimedia computer and to
the AUDIO connector of the PC/DVI AUDIO IN jack of the TV/DVD.
Press INPUT SELECT on the remote control to select PC mode.
Switch on the computer. The TV/DVD can operate as the computer monitor.
Rear of the unit
To PC IN
PC/DVI
AUDIO IN
jack
NOTE:
• The on-screen displays will have a different appearance in PC mode than in TV mode.
• If there is no video signal from the PC when the unit is in PC mode, "No signal" will appear on the TV-screen.
38
51F0101A_eng.indd 38
Amplifier
To Audio (L) Input To Audio (R) Input
Audio cord (not supplied)
To Audio/Video OUT
Audio/Video cord
(not supplied)
VGA cable (not supplied)
Audio cord (not supplied)
(continued)
NOTE:
• To hear sound when using an
external audio amplifier, the
volume of both the unit and the
amplifier must be set above 0
(zero).
For example, if the volume of the
unit is set to 0, you will not be
able to hear any sound, even if
the volume of the amplifier is at its
highest level.
or
Monitor Display modes
MODE Resolution Refresh rate
VGA 640x480 60Hz
VGA 720x400 70Hz
SVGA 800x600 60Hz
XGA 1024x768 60Hz
WXGA 1280x768 60Hz
WXGA 1280x720 60Hz
WXGA 1360x768 60Hz
To return to normal mode
Press INPUT SELECT again.
3/10/08 10:56:12 AM