Felcom - Furuno FELCOM 12 Installation Manual

SAFETY INSTRUCTIONS
WARNING
Do not work inside the
equipment unless totally
familiar with electrical
circuits.
Hazardous voltage which can
cause electrical shock, burn
or serious injury exists inside
the equipment.
Do not approach the
radome closer than 60 cm
when it is transmitting.
Microwave radiation can
cause severe injury or illness.
Radiation level:
10 W/m
Turn off the power at the
mains switchboard before
beginning the installation.
Post a sign near the switch
to indicate it should not be
turned on while the equip-
ment is being installed.
Fire, electrical shock or
serious injury can result if the
power is left on or is applied
while the equipment is being
installed.
Do not install the equipment where
flammable gases are stored.
Fire may result.
2
at 60 cm
CAUTION
Ground the equipment to
prevent electrical shock
and mutual interference.
Confirm that the power supply voltage
is compatible with the voltage rating
of the equipment.
Connection to the wrong power supply
can cause fire or equipment damage. The
voltage rating appears on the label at the
rear of the display unit.
Keep the following compass safe
distances:
Standard
IC-112 0.6 m
IC-212 1.8 m
IB-581 1.4 m
IC-302
0.8 m
IC-303
PP-510 1.0 m
PR-300 0.9 m
Steering
0.5 m
1.3 m
1.0 m
0.6 m
0.8 m
0.7 m
i i i i i i i i i i i i i
i