Table of Contents
Advertisement
16061510-CHAPTER 4
12/13/02 11:48 AM
V C R O
9
Press the DOWN arrow
button to select "SPEED",
then press the RIGHT
arrow button to select
speed at which you want
to record.
10
Press the DOWN arrow
button to select "Mode",
then press the UP/DOWN
arrow buttons to select
"Once", "Wkly", or "Dly".
11
Press the MENU button to exit the menu system and return to
normal viewing.
12
Press the POWER button to turn off the VCR.
IMPORTANT:
•
The TV should be off to record the programs you've chosen. But, if you are recording a channel
that comes through a cable box, be sure to leave the cable box turned on and tuned to the
channel you want to record.
•
When a timer recording is in progress, there is no picture on the monitor because the power is
off. If you want to watch the channel while it's being recorded, press POWER
control only.
•
One-time timer programs clear from memory automatically when the recording is finished.
Daily and weekly programs remain in the timer until you remove them. If power to the TV is
interrupted,timer program will be removed from memory. The clock and calendar, however, must
be reset.
62
C
F
: VCR O
HAPTER
OUR
Page 62
P E R AT I O N
VCR Setup
Timer Record
CH
: 7
START
: 10:30 am
END
: 12:30 pm
CH
Date
: 1/ 01/ 2002
Fri
Speed
: SP
Mode
: Once
Move
Sel.
Exit
VCR Setup
Timer Record
CH
: 7
START
: 10:30 am
END
: 12:30 pm
CH
Date
: 1/ 01/ 2002
Fri
Speed
: SP
Mode
: Once
Move
Sel.
Exit
PERATION
For more information on
selecting tape speeds, see page 68.
To enter additional program
recording times, repeat steps 1-10.
If you enter two program times that
overlap, a program overlap warning
appears on the TV screen, along with
instructions for fixing the overlap.
The timer indicator on the front panel
of the TV illuminates when program
times have been stored.
The TV should be turned off to record
the programs you've chosen.
on the remote
Advertisement
Table of Contents
