Disconnecting the iPhone [DCT]
You can close the Bluetooth connection between the watch and iPhone.
1
Change the mode of the watch to [ DCT ].
The connection is closed and the function hand on the upper right sub dial
points the " OFF " area.
Maximum continuous connection time
To conserve energy, the connection is automatically terminated when approximately six
hours has elapsed since the connection started.
• You may however connect again and start a new six-hour period. (See page 11)
Set the mode to [ DCT ] to use this watch as a standard one in places such as an airplane,
where electronic devices are limited to use.
10
Function hand
on the upper
right sub dial