Monitoring Flexible Netflow; Configuration Examples For Flexible Netflow; Example: Configuring A Flow - Cisco Catalyst 3850 Series Configuration Manual

Configuring Flexible NetFlow
Example: Configuring IPv4 Flexible NetFlow in WLAN (Ingress Direction), on page 44
Example: Configuring IPv6 and Transport Flag Flexible NetFlow in WLAN (Egress Direction), on page
45
Example: Configuring IPv6 Flexible NetFlow in WLAN (Both Ingress and Egress Directions), on page
45

Monitoring Flexible NetFlow

The commands in the following table can be used to monitor Flexible NetFlow.
Table 7: Flexible NetFlow Monitoring Commands
Command
show flow exporter [broker | export-ids | name |
name | statistics | templates]
show flow exporter [ name exporter-name]
show flow interface
show flow monitor [ name exporter-name]
show flow record [ name record-name]
show flow ssid
show sampler [broker | name | name]
show wlan wlan-name

Configuration Examples for Flexible NetFlow

Example: Configuring a Flow

This example shows how to create a flow and apply it to an interface:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# flow export export1
Switch(config-flow-exporter)# destination 10.0.101.254
Switch(config-flow-exporter)# transport udp 2055
OL-28354-01
Cisco Flexible NetFlow Configuration Guide, Cisco IOS XE Release 3SE (Catalyst 3850 Switches)
Monitoring Flexible NetFlow
Purpose
Displays information about NetFlow flow exporters
and statistics.
Displays information about NetFlow flow exporters
and statistics.
Displays information about NetFlow interfaces.
Displays information about NetFlow flow monitors
and statistics.
Displays information about NetFlow flow records.
Displays NetFlow monitor installation status for a
WLAN.
Displays information about NetFlow samplers.
Displays the WLAN configured on the device.
43