Cleaning; Troubleshooting; Fault Causes And Rectification - Kompernass CR 5 A2 Operating Instructions And Safety Instructions

Cleaning

CAUTION
Damage to the device!
► To avoid irreparable damage, ensure that no moisture penetrates the device
during cleaning .
► Do not use any abrasive or solvent-based cleaners as these can damage the
device housing or the device itself .
■ Clean the surfaces of the device with a soft, dry cloth . Use a normal commercial
detergent and water to remove stubborn residue . Ensure that no water gets into
the device .

Troubleshooting

This section contains important information on fault identification and rectification .
Observe the instructions in order to avoid risks and damage .
WArNINg
► Repairs to electrical devices may only be carried out by specialists trained by
the manufacturer . Improper repairs can cause considerable risks to users and
damage to the device .

Fault causes and rectification

The following table will help to identify and rectify minor faults:
Fault
The camera is not
working with the
built-in battery .
The camera does not
work in the vehicle .
The camera does not
record properly during
the journey .
CR 5 A2
Possible cause rectification
The battery is flat . Charge the built-in battery from a
switched-on computer connected to
the
or the on-board electrical system of
your vehicle .
The vehicle's Charge the vehicle's battery .
battery is flat .
The fuse in the Replace the fuse (see section
Changing the fuse) .
car adapter
is defective .
There is a Activate the built-in motion sensor
problem with the (function "Motion detection" in the setup
built-in motion menu) only while the vehicle is parked .
sensor .
Increase the sensitivity of the motion
sensor .
connection on the device,
│
GB
23 ■