Table of Contents
Advertisement
CAUTION:
the storage blade in this manner results in improper airflow and improper cooling that can lead
to thermal damage.
To install the component:
Place the access panel on top of the storage blade. Allow the panel to extend past the rear of the
1.
storage blade approximately 0.8 cm (0.2 in).
Slide the access panel toward the front of the storage blade. The access panel locks into position.
2.
Drive blank
WARNING:
internal system components to cool before touching them.
CAUTION:
before beginning any installation procedure. Improper grounding can cause ESD.
CAUTION:
or the enclosure unless the first drive bay is populated with a drive, and drive bays 2 and 3 and
all device bays are populated with either a component or a blank.
CAUTION:
temperature alarm is triggered under the following conditions:
•
A slow beep and flash (1 every 5 seconds) indicate that the drive drawer is open. The drives
are not fully protected by system air flow.
A fast beep and flash (2 per second)—To avoid drive damage or data loss and storage blade
•
shutdown, close the drive drawer immediately.
When the drives reach critical temperatures, the system shuts down.
To remove the component:
Open the drive drawer.
1.
Do not operate the storage blade with the access panel open or removed. Operating
To reduce the risk of personal injury from hot surfaces, allow the drives and the
To prevent damage to electrical components, properly ground the storage blade
To prevent improper cooling and thermal damage, do not operate the storage blade
Thermal regulation is maintained only when the drive drawer is closed. The drive
Removal and replacement procedures 27
Hide quick links:
Advertisement
Table of Contents
