Mounting the Spreader onto the Vehicle
NOTE: Periodically through the snow season,
verify the mounting devices are secure.
1. Remove the tailgate from the truck.
CAUTION
Before lifting, verify hopper is empty of
material. The lifting device must be able to
support the spreader's weight.
2. Lift the spreader. See appropriate instructions
below.
Regular Capacity: Lift spreader by hooking the loop
located on rear cross channel inside hopper.
NOTE: The loop is located at the approximate
balance point of the spreader. The balance point
may vary with engine fl uid levels, battery, top
screen, or residual material in hopper.
Lifting Loop
Lit. No. 96210/96211, Rev. 00
SPREADER MOUNTING INSTRUCTIONS
High Capacity: Lift spreader by hooking all four loops
located at the corners of the hopper.
Loops
5
June 15, 2008