Installation For Mac; Installing The Ucg102; Installing The Guitar Combos Software - Behringer UCG102 Software Installation Manual

guitar link ucg102
To setup the UCG102, proceed as follows:
1) Power on your computer.
2) Connect the UCG102 with the USB cable to your Mac.
3.2
The Guitar Combos software consists of three different combos. Choose any or all of them for instal-
lation. With the serial number on the CD sleeve you can fully activate one combo. The other combos
can be run in demo mode with the following restrictions:
Saving of sounds is disabled
=
Quits after 30 minutes
=
Total recall is disabled
=
To install a combo on your system, proceed as follows:
1) From the folder "NI Guitar Combos" on your CD, choose the combo you wish to install and open
the respective archive file (ZIP) by double-clicking on its entry.
2) Double-click on the installer icon on the desktop, to start the installation.
3) Follow the on-screen instructions.
20
3.

Installation for Mac

3.1

Installing the UCG102

Installing the Guitar Combos software

Installation for Mac