Disassembly & Reassembly - Samsung CSE700P Plus Service Manual

3 Disassembly and Reassembly
This section of the service manual describes the disassembly and reassembly procedures for the
CSE78**T/CSE98**T monitors.
WARNING: This monitor contains electrostatically sensitive devices. Use caution when handling
these components.
3-1 Disassembly
Cautions:1. Disconnect the monitor from the power source before disassembly.
2. Follow these directions carefully; never use metal instruments to pry apart the cabinet.
3-1-1 Before making Disassembly
1. Disconnector signal cable and power cord
from the monitor.
2. With a pad beneath it, stand the monitor on its
front with the screen facing downward and
the base close to you.
3. Make sure nothing will damage the screen.
3-1-2 Cabinet Disassembly
1. To uncover the 2 uppermost screws. Press in
the end of each screw cap and pull it away
from the cabinet.
2. Remove the 4 screw on the Rear Cover and
pull it toward to remove it.
3-1-3 Removing the Stand
1. Pull the tab outward on the Chassis Bottom
and pull the Tilt and Swivel Base up to
remove it.
3-1-4 Removing the Top Shield
1. Remove the 6 screws on the Top Shield Cover
and remove the Shield.
CSE78**T/CSE98**T
3-1-5 Removing the Bottom Shield
1. Remove the 1 screw on the Bottom Shield
Cover.
2. Lift off the Bottom Shield.
3-1-6 Removing the CRT Socket PCB
1. Disconnect connectors GT186 and GT188 on
the CRT PCB Assembly.
2. Disconnect the CRT Socket PCB Assembly.
3-1-7 Removing the Video PCB Assembly
1. Remove the 4 screws (both side and Rear part
of Main PCB Bracket) on the Video PCB.
2. Disconnect CN104, CN102 and CN103 on the
Video PCB Assembly.
3. Lift off the Video PCB Assembly.
3-1