Jig For Servicing - Marantz SR6005/N1SG Service Manual

JIG FOR SERVICING

When you repair the printing board, you can use the following JIG (Extension cable kit).
Please order to marantz Offi cial Service. Distributor in your region if necessary.
Note: When the connection which is wrong in the JIG (EXTENSION UNIT KIT) is done it becomes cause of damage.
8U-110084S :
• Connection of PCB HDMI JIG
-Preparation-
8U-110084S : EXTENSION UNIT KIT
Insulation sheet (Do not supply it)
Ground lead (Do not supply it)
-Procedures-
(1) Remove the screws, then remove the BACK PANEL.
(2) Remove the screws and the SUPPORTER PCB.
Remove the PCB SIRIUS and the PCB RS232 from the PCB SIDE CNT(Board to board).
Board to board
PCB SIRIUS
PCB RS232
(3) Disconnect the connector board.
Board to board
EXTENSION UNIT KIT
: 1 Set
: 3 sheet
: 3 pcs
Board to board Board to board
24
BRACKET HDMI
SUPPORTER PCB
PCB HDMI