Using The Input Button - RCA F27718, F32718, F36718, MR68R718 User Manual

Rca user's guide television f27718, f32718, f36718, mr68r718

Hide thumbs

Table Of Contents

Table of Contents

Tip

OK When a menu is on the screen, press OK to select the item that is highlighted.

ON•OFF Turns the TV on and off. When the remote is in another mode (VCR, DVD, Satellite, etc.)

To turn off all the RCA,

and the remote is programmed to operate that component, you can press ON•OFF to turn the

GE, and Proscan

components that are

component on and off.

connected to the TV,

PAUSE If you're operating a VCR or DVD player with the remote control, press PAUSE when the

press ON•OFF twice

within two seconds.

videotape or disc is playing to pause playback.

This feature only works

PIP (Picture-In-Picture) Brings up the small Picture-In-Picture window. Press again to remove the

with most RCA, GE and

PIP window.

Proscan products.

PLAY If you're operating a VCR or DVD player, plays the videotape or disc.

REC•VCR+ When the GUIDE Plus+ program guide is on the screen, press REC•VCR+ to program

your VCR to record a program. If the remote is in VCR mode, press REC•VCR+ to start recording.

RESET Resets original settings in several control panels.

REVERSE If you're operating a VCR or DVD player with the remote control, press REVERSE to go

backwards on a videotape or disc.

SAT•CABLE Puts the remote in SAT•CABLE mode. If you set up the Auto Tuning feature (Chapter

3), pressing the SAT•CABLE button automatically tunes the TV to the correct channel.

SKIP If you press this button before you change the channel, the TV waits 30 seconds and

automatically goes back to the original channel. Each time you press SKIP, you add 30 seconds (i.e, if

you press SKIP two times before you change the channel, the TV waits 60 seconds and automatically

turns back to the original channel). Press CLEAR to cancel skip timer.

SOUND Displays the AUDIO PROCESSOR menu.

STOP If you're operating a VCR or DVD player, stops playing the videotape or disc.

SWAP Switches the main picture with the PIP window.

TV Turns on the TV and puts the remote in TV mode. Also displays channel information.

VCR Puts the remote in VCR mode. If you set up the Auto Tuning feature (Chapter 3), pressing the

VCR button automatically tunes the TV to the correct channel.

VPORT Tunes the TV to the VPORT input channel. You can program this button to control a cable

box, audio components, a VCR, DVD or satellite receiver. When programmed, changes the mode of

the remote when the button is pressed. To restore the VPORT button to factory default mode

(unprogrammed), press and hold VPORT, then press 1, 0, 0, and 0.

VOL (up and down) buttons Decrease or increase the TV's volume.