Battery Installation - Memorex MVDP0803 Manual

BATTERY INSTALLATION

Follow these precautions when using batteries in this device:
1. CAUTION – Danger of explosion if battery is incorrectly replaced. Replace only with the same
or equivalent type.
2. Use only the size and type of batteries specified.
3. Be sure to follow the correct polarity when installing the batteries as indicated in the Battery
Compartment. A reversed battery may cause damage to the device.
4. Do not mix different types of batteries together (e.g. Alkaline, Rechargeable and Carbon-zinc)
or old batteries with fresh ones.
5. If the device is not to be used for a long period of time, remove the batteries to prevent damage
or injury from possible battery leakage.
6. Do not try to recharge a battery not intended to be recharged; it can overheat and rupture.
(Follow battery manufacturer's directions.)
7. Remove batteries promptly if consumed.
8. Clean the battery contacts and also those of the device prior to battery installation.
ADDITIONAL BATTERY PRECAUTIONS
WARNING: Risk of fire, explosion, and burns. Do not disassemble, crush, heat above 100°C
(212°F), or incinerate.
Dispose of used batteries promptly according to local recycling or waste regulations. Never put
batteries in mouth. If swallowed, contact your physician or local poison control center. Do not
disassemble and do not dispose of in fire.
CAUTION: Replace battery with exact same battery only. Use of another battery may present
a risk of fire or explosion.
CAUTION: The battery used in this device may present a risk of fire or chemical burn if
mistreated.
Do not use a damaged battery. If a battery pack has leaking fluids, do not touch any fluids.
In case of eye contact with fluid, do not rub eyes. Immediately flush eyes thoroughly with water
for at least 15 minutes, lifting upper and lower lids, until no evidence of the fluid remains. Seek
medical attention.
Do not short the external contacts on a battery.
REMOTE CONTROL (CONTINUED)
BATTERY PRECAUTIONS
1. Insert a pencil, or other pointy object, into the
groove on the Battery Compartment to help
slide the compartment out.
2. Install a CR2025 battery, paying attention to
the polarity
Compartment (positive side up).
3. Replace the Battery Compartment.
12
diagram in the Battery