Furuno FAR-2218 Installation Manual page 51

REAR REAR
9. DE-ICER INSTALLATION. See also "De-icer Kit Installation Instructions" (for TR-
UP radar, C32-01313), issued separately, for the de-icer not fitted at the factory.
If the de-icer is not provided, go to step 10.
Front cover w/de-icer,
inside view
1) Set a locking wire saddle (supplied) at locations (B) and (C) shown in the fol-
lowing figure. Pass the de-icer power cable from cable entrance through the
locking wire saddles (A), (B) and (C) and pull it to the front side.
FRONT FRONT
2) Unfasten the cable band* on the front
cover. Pass the de-icer power cable
through the band then fasten the band.
Connect the cable to TB901 on the
DE-ICER board (03P9573), using the
supplied crimp-on lugs.
*: For the DE-ICER installation kit, un-
fasten the cable band on the cover
supplied. (The original cover can be
discarded.)
B
TB804
Fasten conductor Fasten shield
with screw. with clamp.
TB803
Signal line
DEICER Board (03P9573)
C
B
Cable band Cable band
2. WIRING
NOTE: Do not use
crimp-on lug, to prevent
contact resistance from
increasing.
Coaxial cable
B
C
A
[TEST] button
Voltage Setting
switch
TB901
A
C
B
TB901
2-11