1. INSTALLATION
How to install the Intelligent Hub
1. Use two binding screws (M3 6, supplied) to attach the cable clamp (supplied) to
the bottom of the HUB-3000.
2. Fasten four self-tapping screws ( 4 20, supplied) to secure the unit.
1.8
Switching Hub (option)
Use the HUB-100 to connect sensor networks. This network cannot be connected to
the shipborne LAN network. Further do not connect a commercial PC to this network,
other than for the maintenance.
For the installation procedure, see the operator's manual for HUB-100 (Pub. No.
OMC-35191).
Installation considerations
Keep in mind the following points when selecting a location.
• Locate the hub away from heat sources because of heat that can build up inside the
cabinet.
• Select a location where the vibration is minimal.
• Locate the equipment away from places subject to water splash and rain.
• Make sure that the ground wire is connected between the earth terminal on the hub
and the ship's earth.
• Leave sufficient space at the sides and rear of the unit to facilitate maintenance.
1-20
Binding screw
(M3×6, 2 pcs)
Cable clamp
Bottom view
: Screw holes