Canon FINISHER-C1 Service Manual page 80

CHAPTER 2 FINISHER UNIT BASIC OPERATION
1. Inlet Sensor Delay Jam (11H)
The inlet sensor does not detect paper when feeding an equivalent of 400 mm from when the
copier's delivery signal has been issued.
Copier's delivery signal
Equivalent
of 400 mm
Jam check
Inlet sensor (PI1)
Feed motor (M1)
2. Inlet Sensor Stationary Jam (21H)
The sheet does not move past the inlet sensor when an equivalent of twice the feeding length of
the sheet has been fed after the sensor turned on.
Equivalent
of size x 2
Jam check
Inlet sensor (PI1)
Feed motor (M1)
3. Buffer Inlet Sensor Delay Jam (12H)
The buffer inlet sensor does not detect paper when an equivalent of 100 mm has been fed after
the inlet sensor turned on.
Jam check
Inlet sensor (PI1)
Buffer inlet sensor
(PI17)
Feed motor (M1)
2-50
Normal
Figure 2-271
Normal
Figure 2-272
Equivalent
of 100 mm
Normal
Figure 2-273
COPYRIGHT © 1998 CANON INC. FINISHER-C1/SADDLE FINISHER-C2 REV. 0 DEC. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
Copier's delivery signal
Equivalent
of 100 mm
Jam check
Inlet sensor (PI1)
Feed motor (M1)
Jam check
Inlet sensor (PI1)
Feed motor (M1)
Jam check
Inlet sensor (PI1)
Buffer inlet sensor
(PI17)
Feed motor (M1)
Jam
Equivalent
of size x 2
Jam
Equivalent
of 100 mm
Jam