Canon FINISHER-C1 Service Manual page 205

7. E5F6 (faulty paper pushing plate motor; detail code 03)
Cause
Paper pushing leading edge
position sensor (PI5S)
Saddle stitcher controller PCB
Paper pushing plate motor
(M8S)
Saddle stitcher controller PCB
8. E5F6 (faulty paper pushing plate motor; detail code 04)
Cause
Paper pushing plate motor
clock sensor (PI1S)
Saddle stitcher controller PCB
Paper pushing plate motor
(M8S)
Saddle stitcher controller PCB
COPYRIGHT © 1998 CANON INC.
Step Checks
Check the paper pushing plate
1
leading edge position sensor. Is
the sensor normal?
Does the paper pushing plate
2
motor operate at a specific
timing?
Replace the paper pushing plate
3
motor. Is the problem corrected?
Step Checks
Check the paper pushing plate
1
motor clock sensor. Is the sensor
normal?
Does the paper pushing plate
2
motor operate at a specific
timing?
Replace the paper pushing plate
3
motor. Is the problem corrected?
FINISHER-C1/SADDLE FINISHER-C2 REV. 0 DEC. 1998 PRINTED IN JAPAN (IMPRIME AU JAPON)
CHAPTER 6 TROUBLESHOOTING
Yes/No
Replace the sensor.
No
Replace the saddle stitcher
Yes
controller PCB.
Check the paper pushing plate
No
drive mechanism. If a fault is
found, correct it; otherwise, go to
step 3.
End.
Yes
Replace the saddle stitcher
No
controller PCB.
Yes/No
Replace the sensor.
No
Replace the saddle stitcher
Yes
controller PCB.
Check the butting plate drive
No
mechanism. If a fault is found,
correct it; otherwise, go to step 3.
End.
Yes
Replace the saddle stitcher
No
controller PCB.
Action
Action
6-33