Table of Contents
Advertisement
10. Video signal adjustment procedure
The adjustment process mode menu is listed in Section 5.
Signal generator level adjustment check (Adjustment to the specified level)
•
Composite signal PAL/SECAM
•
RGB signal
•
15K component signal (50 Hz)
•
33K component signal (50 Hz)
10.1. Entering the adjustment process mode
Enter the adjustment process mode according to Section 3.
10.2. TUNER adjustment
Adjustment point
1
Setting
2
Auto adjustment
performance
10.3. NTSC signal adjustment
Adjustment point
1
Setting
2
Auto adjustment
performance
: 0.7Vp-p ± 0.02Vp-p (Pedestal to white level)
: 0.7Vp-p ± 0.02Vp-p
: 0.7Vp-p ± 0.02Vp-p (Pedestal to white level)
: Y level
: 0.7Vp-p ± 0.02Vp-p
: PB, PR level
: 0.7Vp-p ± 0.02Vp-p (Pedestal to white level)
: Y level
: 0.7Vp-p ± 0.02Vp-p
: PB, PR level
Adjustment conditions
[Signal]
NTSC split field colour Bar
RF signal UV
[Terminal]
TUNER
Adjustment process
[TUNER ADJ]
page 3/21
Adjustment conditions
[Signal]
N358
Full field colour Bar Signal
[Terminal]
INPUT2 video input
Adjustment process
[N358 ADJ]
page 3/21
Adjustment procedure
•
Feed the NTSC Split Field colour bar signal to TUNER.
•
Make sure the NTSC colour bar pattern has the sync level of 7:3 with the
picture level.
Bring the cursor on [TUNER ADJ] and press [ENTER].
[TUNER ADJ OK] appears when finished.
Adjustment procedure
•
Feed the NTSC full field colour bar signal (75% colour saturation) to
INPUT2 video input.
[VIDEO input signal]
100% white
Bring the cursor on [N358 ADJ] and press [ENTER].
[N358 ADJ OK] appears when finished.
3 – 8
LC-60XF3DT
[US-10CH]
100% white
Black
Advertisement
Table of Contents
