Other Information
Noisy stereo reception (analog channels only)
•
May be a weak station. Change the Sound Type to Mono (instructions on page 26).
No picture, no sound but TV is on
•
Maybe the Signal Source is set wrong. Go to page 11 for more instructions.
•
You may have the wrong video input channel selected. Use the ANTENNA button to toggle through the available
video input channels.
•
If the device you're connected to has "progressive scan" and you aren't receiving a picture using a component
(Y Pb Pr) connection, you need to change the setting from progressive to interlace. The procedure for changing
this varies. Look for a button on the front of the device (it might be called resolution or display), or see if there
is a switch on the back (it might be labeled "int/prog" or something similar), or the item might be in the menu
system. Consult the user's guide for instructions.
Sound okay, picture poor (analog channels only)
•
Check antenna connections. Make sure all of the cables are firmly connected to the jacks.
•
Try adjusting sharpness to improve weak signals. Go to page 28 for more instructions.
Black box appears on the screen
•
Closed caption might be on. Check CC in the SETUP menu. Go to page 29 for more instructions.
Problems with Remote Control
The remote control doesn't work
•
Something might be between the remote and the remote sensor on the device. Make sure there is a clear path and
point directly at the TV.
•
Maybe batteries in the remote are weak, dead or installed incorrectly. Put new batteries in the remote.
Problems with Parental Controls
Can't select a certain channel
•
The channel may be blocked or not approved through PARENTAL CONTROL SETTINGS.
The rating limits don't work
•
You must activate the settings. Go to page 19 for instructions.
I don't remember my password and I want to unlock the TV
•
If you forget your password, you can reset it. Make sure the TV is off. Press VOL- on the TV's front panel and then
CLEAR on the remote for approximately 5 seconds. The TV turns on. Enter a new password next time you access
the PARENTAL CONTROL menu or the TIME menu.
The Parental Controls won't let me watch a program even though it's not rated as violent
•
Maybe the movie was given an NR (Not Rated) status. Check to see if the Exempt Prgms option is Locked. Refer to
page 23 for instructions.
Connection Problems with a DVD Player, Set-top Box etc.
•
If the device you're connected to has "progressive scan" and you aren't receiving a picture using a component
(Y Pb Pr) connection, you need to change the setting from progressive to interlace. The procedure for changing
this varies. Look for a button on the front of the device (it might be called resolution or display), or see if there
is a switch on the back (it might be labeled "int/prog" or something similar), or the item might be in the menu
system. Consult the user's guide for instructions.
40
Chapter 4