Jump Lead Starting - Porsche 911 Turbo Manual

Replacing the remote control battery
The battery should be changed when the range of
the radio remote control becomes smaller or
when the light-emitting diode no longer flashes
when the remote control is operated.
218
Practical Tips, Minor Repairs
1. Using your finger nail or a small screwdriver,
carefully lift off the cover of the key grip
(arrow).
2. Replace the battery (paying attention to the
polarity).
Replacement battery (Lithium CR 2032, 3 Volt)
3. Replace cover and press together firmly.
Please observe the disposal instructions for
batteries.

Jump Lead Starting

f Please observe the chapter "EMERGENCY
UNLOCKING OF LUGGAGE COMPARTMENT
LID" on page 213.
f Please observe the chapter "BATTERY" on
page 214.
If the battery is flat, the battery of another vehicle
can be used to start the car with the aid of jump
leads.
Both batteries must be 12 V types. The capacity
(Ampere hours, Ah) of the donor battery must not
be substantially less than that of the discharged
battery.
The discharged battery must be correctly
connected to the vehicle's electrical system.
Warning!
Risk of damage and injury due to short
circuit.
f Use only standard jump leads with sufficient
cross section and completely insulated
clamps.
Follow the jump lead manufacturer's instruc-
tions.
f Route the jump leads so that they cannot be
caught by moving parts in the engine compart-
ment.
The vehicles must not be in contact, otherwise
current might flow as soon as the positive
terminals are connected.