Remote Control Handset; Inserting Batteries; Switching On/Off; To Switch The Tv On - Technika 32C-934 Operating Instructions Manual

Remote Control Handset

Inserting Batteries

• Remove the battery cover located on the back of
the handset by gently pulling backwards from the
indicated part.
• Insert two AAA/R3 or equivalent type batteries
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.
Note: Remove the battery from remote control
handset when it is not to be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries. Remote range is approximately 7m/23ft.

Switching On/Off

To Switch the TV On

• Connect the power cord to the 220-240V AC 50 Hz.
Then the standby LED lights up.(The led will blink
during the standby On/Off)
• To switch on the TV from standby mode either:
• Press the " " button, P+ / P- or a numeric button
on the remote control.
• Press the " " button, - or + button on the TV. The
TV will then switch on.
Note: If you switch on your TV via PROGRAMME
UP/DOWN buttons on the remote control or on the
TV set, the programme that you were watching last
will be reselected.
By either method the TV will switch on.

To Switch the TV Off

• Press the " " button on the remote control or press
the " " switch on the TV, so the TV will switch to
standby mode.
• To power down the TV completely, unplug the
power cord from the mains socket.
Note: When the TV is switched to standby mode,
standby LED can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active.
A01_woypbpr_MB60_[GB]_3902UK_IDTV_NICKEL16_32910W_10071968_50183639.indd 11 A01_woypbpr_MB60_[GB]_3902UK_IDTV_NICKEL16_32910W_10071968_50183639.indd 11

Input Selection

Once you have connected external systems to
your TV, you can switch to different input sources.
Press "SOURCE" button on your remote control
consecutively for directly changing sources.
Note: YPbPr mode can be used only when you
connect a device that has a YPbPr output through the
PC input with YPbPr to PC cable (not supplied).

Basic Operations

You can operate your TV using both the remote
control and onset buttons.

Operation with the Buttons on the TV

Main menu OSD cannot be displayed via control
buttons. "+/-" buttons will function as volume up/down
as default. Even if you set other functions for these
buttons, "+/-" buttons will perform as default after a
short while.

Volume Setting

• Press " P/V/AV" button once and then use "+/-"
buttons to increase or decrease volume, so a volume
level scale (slider) will be displayed on the screen.
While Tv is on, +/- button can use as volume + or
volume - as default.

Programme Selection

• Press " P/V/AV" button once and then use "+/-" buttons
to change channel. By pressing "+/-" button,you can
select the next or previous programme.

AV Mode

• Hold the " P/V/AV" button, source OSD will be displayed
in a few second.

Operation with the Remote Control

• The remote control of your TV is designed to control
all the functions of the model you selected. The
functions will be described in accordance with the
menu system of your TV.
English - 11 -
31.03.2011 10:54:15 31.03.2011 10:54:15